Manufacturing Articles

Technical articles tagged Manufacturing: selection guidance, design rules and field data for Manufacturing connectors.

FEATURED ARTICLE

Box Header vs Pin Header: When a Shrouded Connector Is Worth It

Box Header vs Pin Header: When a Shrouded Connector Is Worth It A box header is essentially a pin array surrounded by a molded shroud. That extra housing increases footprint and cost, but it can also protect contacts, guide mating, support polarization and provide a latch. The right choice depends less on the electrical schematic […]

Read More →

Manufacturing Articles

Connector Basics

Box Header vs Pin Header: When a Shrouded Connector Is Worth It

Box Header vs Pin Header: When a Shrouded Connector Is Worth It A box header is essentially a pin array surrounded by a molded shroud. That extra housing increases footprint and cost, but it can also protect contacts, guide mating, support polarization and provide a latch. The right choice depends less on the electrical schematic […]

Read More →
Connector Basics

Connector Housing Materials: PBT vs LCP vs PA9T/PPA vs PPS

Connector Housing Materials: PBT vs LCP vs PA9T/PPA vs PPS The connector housing locates contacts, maintains creepage and clearance, survives soldering and protects the mating interface. Selecting the wrong resin grade can lead to reflow distortion, moisture-related dimensional change, latch fatigue or chemical damage. The most important correction to many material comparisons is this: polymer […]

Read More →
Connector Basics

Board-to-Board Connector Mating Cycles: Durability and Life Expectancy

Board-to-Board Connector Mating Cycles: Durability and Life Expectancy A mating-cycle rating states how many complete insertions and withdrawals a connector has passed under defined test conditions. It does not guarantee the same life in a dusty service bay, a vibrating vehicle or a misaligned test fixture. The useful engineering question is not simply “How many […]

Read More →
Connector Basics

Server Backplane Connector Selection for Data Center Hardware

Server Backplane Connector Selection for Data Center Hardware A server “backplane connector” can refer to several different interfaces: the drive-facing connector, a high-speed cable connection, a controller-to-backplane board connector, an OCP NIC interface or a power-distribution connector. Treating all of them as generic board-to-board connectors creates electrical and mechanical risk. Each location has a different […]

Read More →