Connector Selection Articles

Technical articles tagged Connector Selection: selection guidance, design rules and field data for Connector Selection connectors.

FEATURED ARTICLE

Locking DC Jacks vs Standard Barrel: Retention for Portable Equipment

A standard barrel plug is held by friction alone. What screw-lock and twist-lock actually buy, and what they cost.

Read More →

Connector Selection Articles

Connector Basics

Connector Housing Materials: PBT vs LCP vs PA9T/PPA vs PPS

Connector Housing Materials: PBT vs LCP vs PA9T/PPA vs PPS The connector housing locates contacts, maintains creepage and clearance, survives soldering and protects the mating interface. Selecting the wrong resin grade can lead to reflow distortion, moisture-related dimensional change, latch fatigue or chemical damage. The most important correction to many material comparisons is this: polymer […]

Read More →
Connector Basics

Board-to-Board Connector Mating Cycles: Durability and Life Expectancy

Board-to-Board Connector Mating Cycles: Durability and Life Expectancy A mating-cycle rating states how many complete insertions and withdrawals a connector has passed under defined test conditions. It does not guarantee the same life in a dusty service bay, a vibrating vehicle or a misaligned test fixture. The useful engineering question is not simply “How many […]

Read More →
Connector Basics

Mezzanine Connector Selection: Pitch, Stack Height and Alignment

Mezzanine Connector Selection: Pitch, Stack Height and Alignment A mezzanine connector joins two parallel PCBs with a plug and receptacle. It can deliver high circuit density and a repeatable board-to-board distance in a much smaller volume than a conventional 2.54 mm header. That precision creates its own design constraints. Pitch, mated height, capture range, PCB […]

Read More →
Connector Basics

Pin Header Current Rating: Derating, Temperature Rise and Parallel Contacts

Pin Header Current Rating: Derating, Temperature Rise and Parallel Contacts Search results often assign one current value to an entire pitch—such as “3 A per pin for a 2.54 mm header.” That is not a safe design rule. Current rating belongs to a specific mated connector pair under defined test conditions. The female contact, contact […]

Read More →
Connector Basics

High-Speed Board-to-Board Connector Design Guide

High-Speed Board-to-Board Connector Design Guide A connector does not become “high-speed” because it has fine pitch. High-speed performance comes from a controlled contact/ground architecture, a repeatable PCB launch and measured channel data. The correct selection process starts with the interface and channel budget, then evaluates the connector’s S-parameters, pin map, stack height and breakout geometry. […]

Read More →
Connector Basics

Pin Header and Female Header Connectors: A Complete Design Guide

Pin Header and Female Header Connectors: A Complete Design Guide Pin headers and female headers are among the simplest PCB interconnects, but small specification differences can determine whether the final assembly fits, carries the required current and survives repeated service. This guide explains the parameters that belong on a drawing or RFQ: pitch, circuit count, […]

Read More →