Locking DC Jacks vs Standard Barrel: Retention for Portable Equipment
A standard barrel plug is held by friction alone. What screw-lock and twist-lock actually buy, and what they cost.
Read More →Technical articles tagged Connector Selection: selection guidance, design rules and field data for Connector Selection connectors.
A standard barrel plug is held by friction alone. What screw-lock and twist-lock actually buy, and what they cost.
Read More →
Why plugs walk out of vibrating panels, which jack parameters actually resist it, and how to stop detection switches from chattering.
Read More →
Continuous write load changes the socket requirements: thermal resistance to the board replaces cycle life as the deciding parameter.
Read More →
What the detection switch actually reports, how it changes firmware behaviour, and the cases where 6 pins remain the correct choice.
Read More →
Selection by deployment scenario: indoor gateways, outdoor cabinets, vehicle telematics, remote meters and handheld terminals each need a different form factor and mechanism.
Read More →
How the three SIM socket mechanisms differ in retention, wear and shock behaviour, and which one survives field service versus daily user access.
Read More →
Compare M8, M12, M23, MIL-style, and Deutsch-style circular connectors by size, locking method, sealing, signal type, and application.
Read More →
Build a board-to-board connector pin budget for power, returns, differential signals, controls, test access, future margin, and mechanical constraints.
Read More →
Box Header vs Pin Header: When a Shrouded Connector Is Worth It A box header is essentially a pin array surrounded by a molded shroud. That extra housing increases footprint and cost, but it can also protect contacts, guide mating, support polarization and provide a latch. The right choice depends less on the electrical schematic […]
Read More →
Board-to-Board Connector Selection Guide: A Practical Engineering Workflow Choosing a board-to-board (B2B) connector is not simply a matter of matching pitch and pin count. The connector also defines board spacing, assembly tolerance, serviceability, signal integrity, current density and, often, the mechanical architecture of the enclosure. This guide turns those requirements into a practical selection workflow. […]
Read More →